| Author |
Problems with k700 flashing using davinci |
imhotepp
Joined: Nov 03, 2004
Posts: 74
PM |
Hi,
bought to credits from davinci and launched their client connected to my k700 through dss-25 (which shows as dss20 under Device Manager, is this normal?)
I used my first credit to unlock the phone which apparently went well, no errors but not tested a different sim card yet.
However when I tried flashing to the newest formware R2Y, I first flashed cda29 to cda36 succesfully and then in the middle of flashing the r2y firmware I was getting block not accepted errors , I kept removing the battery reinserting and switching the phone on again, but now the phone has been dead and I left the battery out for almost 30 minutes and still it wont switch on?
What should i do? |
|
|
merolliaz
Joined: Oct 05, 2004
Posts: 7
From:
PM |
I had the same problem with my S700i ( see this: http://www.esato.com/board/viewtopic.php?topic=94279#post1314242 ) and i had to flash an old firmware (that i had, not taken from Davinci FTP) with a generic CDA information, and after that, I got the latest firmware from SEUS. |
imhotepp
Joined: Nov 03, 2004
Posts: 74
PM |
Well, my biggest problem now is switching on the phone, I believe to flash anything you need to push the on button slightly. That doesnt work now
How long should I wait with the battery removed from the phone? |
merolliaz
Joined: Oct 05, 2004
Posts: 7
From:
PM |
Maybe, 10 seconds i think. But would suggest you to reboot your PC and try again. |
imhotepp
Joined: Nov 03, 2004
Posts: 74
PM |
I left the battery outside for an hour but still the phone will not turn on when I place the battery back in.
Will it turn on again? What must I do to recover it? |
merolliaz
Joined: Oct 05, 2004
Posts: 7
From:
PM |
You must complete the flashing procedure. After that, you must do the finalization procedure. Your phone won't start without that.
If you're having problems with the latest firmware, try flashing another one (an older firmware instead). |
muppet
Joined: Jan 09, 2005
Posts: 165
From: Auckland, New Zealand
PM, WWW
|
Quote:
|
On 2005-07-26 22:27:04, imhotepp wrote:
Well, my biggest problem now is switching on the phone, I believe to flash anything you need to push the on button slightly. That doesnt work now
How long should I wait with the battery removed from the phone?
|
|
The "press power button" isn't there to turn the phone on, it's so that Davinci gets a signal via the cable to start the phone flash.
You should still be able to restart the phone flash using Davinci even though the phone won't currently turn on.
Leaving your battery out for 2 years will not help, if the firmware isn't complete in the phone's flash it won't power on.
|
imhotepp
Joined: Nov 03, 2004
Posts: 74
PM |
Well, even if I press the power on button the davinci client still keeps waiting the power button to be pushed, meaning it doesnt get the signal or what?
The thing is davinci client now doesnt work anymore |
imhotepp
Joined: Nov 03, 2004
Posts: 74
PM |
When I try to recover, the client is stuck here
Quote:
|
Client Version 13.51
Shortly press Power button!
|
|
I keep pressing the power button but it remains there
I desperately need help, I emailed davinci support but no response yet |
imhotepp
Joined: Nov 03, 2004
Posts: 74
PM |
Here is the full error log of the client
--------------26/07/2005 19:19:19--------------
Client Version 13.51
Shortly press Power button!
Detected SonyEricsson:
K700/K300/K500/S700/Z500.
Status Ok, OTP Close, CID29, PAF1
IMEI: 354006-00-368028
Loading Main File. Ok!
Loading FS File. Ok!
Flash file CID:36
Phone CID:29
Phone CID and Flash file CID mismatch. Please
use CID Ignoring option,
or flash Transform BIN to phone
Flashing 217 blocks...
Block Not accepted
Execution Time - 00:00:21
Error: 0x005556
--------------------------------------------
--------------26/07/2005 19:20:52--------------
Client Version 13.51
Shortly press Power button!
Execution Time - 00:00:31
Stopped!
--------------------------------------------
--------------26/07/2005 19:21:30--------------
Client Version 13.51
Shortly press Power button!
Execution Time - 00:00:17
Stopped!
--------------------------------------------
--------------26/07/2005 19:29:37--------------
Client Version 13.51
Shortly press Power button!
Detected SonyEricsson:
K700/K300/K500/S700/Z500.
Phone Color RED
Status Ok, OTP Close, CID29, PAF1
IMEI: 354006-00-368028
Loading Main File. Ok!
Flash file CID:36
Phone CID:36
Flashing 217 blocks. Ok!
Flash file CID:36
Phone CID:36
Flashing 101 blocks...
Block Not accepted
Execution Time - 00:06:29
Error: 0x005556
--------------------------------------------
--------------26/07/2005 19:30:17--------------
Client Version 13.51
Shortly press Power button!
Execution Time - 00:00:11
Stopped!
--------------------------------------------
--------------26/07/2005 19:32:25--------------
Client Version 13.51
Shortly press Power button!
Detected SonyEricsson:
K700/K300/K500/S700/Z500.
Phone Color RED
Status Ok, OTP Close, CID29, PAF1
IMEI: 354006-00-368028
Flash file CID:36
Phone CID:36
Flashing 217 blocks...
Block Not accepted
Execution Time - 00:01:34
Error: 0x005556
--------------------------------------------
--------------26/07/2005 19:33:46--------------
Client Version 13.51
Shortly press Power button!
Detected SonyEricsson:
K700/K300/K500/S700/Z500.
Recovering process started!
Status Ok, OTP Close, CID29, PAF1
IMEI: 354006-00-368028
Flashing 1 blocks...
address: 00000000, block: 1/1
cert red29 flashed successfully
Recovered successfully!
Execution Time - 00:00:38
Reflash MAIN Firmware now!
--------------------------------------------
--------------26/07/2005 19:34:05--------------
Client Version 13.51
Shortly press Power button!
Detected SonyEricsson:
K700/K300/K500/S700/Z500.
Status Ok, OTP Close, CID29, PAF1
IMEI: 354006-00-368028
Flash file CID:36
Phone CID:36
Flashing 217 blocks...
Block Not accepted
Execution Time - 00:00:11
Error: 0x005556
--------------------------------------------
--------------26/07/2005 19:41:02--------------
Client Version 13.51
Shortly press Power button!
Detected SonyEricsson:
K700/K300/K500/S700/Z500.
Execution Time - 00:00:10
Error: 0x002A24
--------------------------------------------
--------------26/07/2005 19:41:20--------------
Client Version 13.51
Shortly press Power button!
Execution Time - 00:00:09
Stopped!
-------------------------------------------- |
muppet
Joined: Jan 09, 2005
Posts: 165
From: Auckland, New Zealand
PM, WWW
|
Are you sure your battery isn't just flat?
That's how it would seem to me, either that or something is taking over the COM port on your PC.
I've never seen a flash manage to kill a phone so badly that you can't still boot it into service mode somehow.
|
imhotepp
Joined: Nov 03, 2004
Posts: 74
PM |
I have put it on the charger but there is no visible indication that it is charging
When on the cradle, if i press the power button, the green led on the dss-25 lights up when I release the power button on the phone, the green led goes back off  |
619
Joined: Jun 19, 2002
Posts: > 500
From: if you dont like my posts, IGN
PM |
i noticed that you are flashing cid36 file... and your phone is cid29
try using latest client http://www.davinciteam.com/client.zip
take off battery and start
try to get the cid29 to cid36 file from the FTP
upload w/o finalization
then upload MAIN and FS (check the main and fs)(make sure u got cid36 file)
then finalized it (1 credit)
hope this works
[addsig] |
imhotepp
Joined: Nov 03, 2004
Posts: 74
PM |
Isnt Client Version 13.51 the latest?
Quote:
|
i noticed that you are flashing cid36 file... and your phone is cid29
try to get the cid29 to cid36 file from the FTP
upload w/o finalization
then upload MAIN and FS (check the main and fs)(make sure u got cid36 file)
then finalized it (1 credit)
|
|
I did succesfuly flash cid29 to cid36 without finalization
--------------26/07/2005 19:29:37--------------
Client Version 13.51
Shortly press Power button!
Detected SonyEricsson:
K700/K300/K500/S700/Z500.
Phone Color RED
Status Ok, OTP Close, CID29, PAF1
IMEI: 354006-00-368028
Loading Main File. Ok!
Flash file CID:36
Phone CID:36
I am getting problems with flashing cid36 main and fs files |
imhotepp
Joined: Nov 03, 2004
Posts: 74
PM |
Hello
Indeed the battery was flat, after charging it fully I have come back to my original problem, when flashing I get "block not accepted" error.
I have tried to reduce the speed of DSS3 to 115200 but still getting this error.
Quote:
|
Client Version 13.51
Shortly press Power button!
Detected SonyEricsson: K700/K300/K500/S700/Z500.
Phone Color RED
Status Ok, OTP Close, CID29, PAF1
IMEI: 354006-00-368028
Loading Main File. Ok!
Loading FS File. Ok!
Flash file CID:36
Phone CID:36
Flashing 217 blocks...
Block Not accepted
Execution Time - 00:01:05
Error: 0x005556
|
|
what should I do? |
|
|
Posted: 2005-07-26 21:36
