| Author |
T230 - T28 cable communication problem |
amitn
Joined: Mar 03, 2005
Posts: 8
PM |
When I connected my T230 with PC by using ERI T28 cable, it sends continuous data on COM port. Which is observed in HyperTerminal software at 115200 baud rate.
What is this data? How to switch the mode of the T230 so that this data will stop & T230 will be in condition to respond for AT commands?
|
|
|
whizkidd
Joined: May 14, 2004
Posts: > 500
From: India
PM, WWW
|
Hi there m8! I would have helped you surely if i knew anything about that. I have seen you have posted the same question earlier too. Good luck. Can you tell me what exactly are you trying to do? :-)
This message was posted from a T230 |
amitn
Joined: Mar 03, 2005
Posts: 8
PM |
Thnx for reply.
Actually I want to write a simple program to transmit SMS by using AT commands. |
phsychomantis
Joined: Jan 24, 2005
Posts: 146
PM |
Have you tried using dcu11 cable
This message was posted from a T230 |
whizkidd
Joined: May 14, 2004
Posts: > 500
From: India
PM, WWW
|
Is the T230 Capable of doing such stuff? Will FMA be of any help for this?
This message was posted from a T230 |
phsychomantis
Joined: Jan 24, 2005
Posts: 146
PM |
Have you tried using dcu11 cable
This message was posted from a T230 |
whizkidd
Joined: May 14, 2004
Posts: > 500
From: India
PM, WWW
|
Is the T230 Capable of doing such stuff? Will FMA be of any help for this?
This message was posted from a T230 |
amitn
Joined: Mar 03, 2005
Posts: 8
PM |
Have you tried using dcu11 cable
- No, I don't have dcu11 cable.
|
|
|
Posted: 2005-03-03 10:43
