| Author |
AT command for "quit" in T610 |
hkmichael
Joined: Feb 21, 2005
Posts: 4
From: Hong Kong
PM |
Hi everybody! Nice to meet you here.
I'm doing a project about remote control on IR devices using T610. The project's main program is written in C, and the menu generated is generated by sending AT command to the phone. Now I find that if I put "quit" item in the menu, it is quite not user-friendly. So, I wish to ask that what is the AT command for "quit" button? And how can I put "return" button's AT command in my program? Thank you very much.
Michael | |
|
hkmichael
Joined: Feb 21, 2005
Posts: 4
From: Hong Kong
PM |
I'm in hurry about this! Maybe I ask once again here.
Now when I press return button in Accessory Submenus, I wish to go to the prevoius page. I've seen one user that found an AT command for the return button, but when I put in my main program and then tried, the command forced to quit from all the menus and then went to the startup window of T610. Then when I pressed the return button in submenu, the submenu disappeared and then returned to the Accessories Main Menu. So, I wish to know what the corresponding AT command for return button (AT+CKPD and EAMI) and how I can put in my C program so that when I pressed the return button, I can see the previous page. Thank you very much!
Michael
michaelhku2002@yahoo.com.hk |
GOwin
Joined: Jan 17, 2002
Posts: > 500
From: .uʍop ǝpısdn s&
PM, WWW
|
According to this older thread with the same topic: AT+CKPD=":R",30,5
I'm locking this thread. Please continue there if you wish.
[ This Message was edited by: GOwin on 2005-03-24 14:31 ] | |
|
Access the forum with a mobile phone via esato.mobi
|
Posted: 2005-02-21 13:41
