| Author |
problems ma-600 infrared adaptor |
racingboy
Joined: Apr 26, 2002
Posts: 255
From: belgium uit limburg
PM |
hi
ive just bought a ma-600 infrared adaptor and if i put it in the com port, and instal the program, he just wont find it, i put it in com 1 and he sais i have to put it in com 4 but i dont have a com 4 so what can i do???
thanks
_________________
T68I rules (untill i get my next one  )(04-05-2002)
mca-20 communicam(04-06-2002)
www.pbase.com/kris_vv almost every day updated!
www.gsmtest.nl---> nederlandse gebruikers forum!
[ This Message was edited by: laffen on 2002-06-21 17:09 ] | |
|
ESTOR
Joined: Apr 20, 2002
Posts: > 500
From: Singapore
PM |
Have you enabled COM1 in your BIOS?
==========================
Check the system BIOS of your mainboard. The hardware resource of the COM port should be set as: COM1 -- 3F8-3FF, IRQ4; COM2 -- 2F8-2FF, IRQ3. The COM port must be Enabled. If MA-600 is connected to COM2, COM2 should be set as standard UART port. You should not enable the Infrared feature of COM2.
==========================
You can also try changing your "COM1" to COM4 by changing the settings in the BIOS, by changing the IRQ and the I/O range . | |
|
Access the forum with a mobile phone via esato.mobi
|
Posted: 2002-06-21 17:47
