| Author |
help plz with s/e image editor |
jimmy mumu
Joined: Feb 08, 2003
Posts: 10
From: sheffield
PM |
i've just downloaded the image editor for the t68i. when i plug my data cable in the image editor can't find it but if i connect to my other s/e the t68/68i handset manager it finds it ok. any help please. thanx |
|
|
t68i_alex
Joined: Feb 23, 2003
Posts: 13
From: Kiev, Ukraine
PM |
Do you have SE Mobile Phone Monitor driver installed? When installed, there should be a menu in SE MyPicturesr under Help. Check COM port setup there.
Mobile Phone Monitor package is available on SE site.
Hope this helps.
ALEX |
jimmy mumu
Joined: Feb 08, 2003
Posts: 10
From: sheffield
PM |
does that mean i've got to get a com cable from mobile to pc, only i've been trying to use the usb data cable. after i downloaded the mobile phone moniter it would only go to a com port not a usb port. so it couldn't find my phone. i know it all sounds dumb but i'm a beginer at this. thanks again |
jimmy mumu
Joined: Feb 08, 2003
Posts: 10
From: sheffield
PM |
still waiting for an answer from anyone plz |
ph1201
Joined: Mar 02, 2003
Posts: 4
PM |
I can't even INSTALL the image editor.
Installation proceeds until I get a message that some installation stuff is PENDING and I should continue with installation after a reboot.
This happens over and over.
Anyone any idea?
Peter |
ph1201
Joined: Mar 02, 2003
Posts: 4
PM |
Solved the installation problem.
It turned our that there was a RUNDLL32 entry with some parameters instead of a program shortcut in the program group, obviously left there by the installation program.
Deleted the program group manually and ran installation routine again and installation worked without starting over now.
Can't say anything about the software itself since I ha no time to check it out.
Peter |
|
|
Posted: 2003-02-25 14:19
