| Author |
P1 not recognised by computer. |
the_carlisle
Joined: Feb 10, 2009
Posts: 2
PM |
Hey!
I have a p1i upaded to the latest firmware.
When i connect my phone to my pc using my data cable, it doesnt recognise it. i have done a factory resest on the phone, tried many operating systems, reformatted several times with no luck. phone on both modes, storage and pc.
it does however work on other pc's. i have tried differnt usb ports, installing differnt usb controller drivers. the lot. i havent looked in my bios because all my other usb perepherals are working fine.
im suspecting it could be my cable (as when i use it others pc's it with a diferent cable). if somebody could help i would be forever gratful.
regards,
jaymie. | |
|
Maratonmannen
Joined: Dec 06, 2003
Posts: > 500
From: Stockholm, Sweden
PM |
Welcome to Esato!
What´s your operating system and PC Suite version installed?
_________________
W960i | HBH-DS980
P1i GW1 | PDair Sleeve
[ This Message was edited by: Maratonmannen on 2009-02-10 17:21 ] |
the_carlisle
Joined: Feb 10, 2009
Posts: 2
PM |
Thanks!
You know when you are talkign and thinking about somthing, and because of you activly thinking about it, you think of the soloution, turned out to be the cable!
didnt think about until i typed up the post. One of the pins was pressed down, so i pulled it up again.
Cheers for the reply none the less!
Jaymie. | |
|
Access the forum with a mobile phone via esato.mobi
|
Posted: 2009-02-10 18:00
