| Author |
E-cell screen protectors. |
blerk
Joined: Jun 12, 2008
Posts: > 500
From: London, UK
PM |
Does anyone here also have bad experience with screen protectors from E-cell? I got a 6 pack from ebay and they're cheap but also total crap, no matter how careful and tidy you are, the corners will never stick to the screen properly, leaving some sort of airbubble in there, VERY annoying. And also the "cut to size" P1i ones are not wide enough you will end up with some space on each side, which is also very annoying. Thats another 2.99 pounds down the drain. The plastic is just too hard or something, I have 2 of my 6 left and I have given up on applying it to my P1i. Guess I should fork out a tenner for a branded one, which are re-usable if all is right, right?
TL;DR: E-cell sucks, don't buy from them.
[ This Message was edited by: blerk on 2008-11-12 15:19 ] | |
|
Bhavv
Joined: Jun 07, 2007
Posts: > 500
PM |
I just bought a T700 with a pack of 6 screen protectors. The first one I applied had some air bubbles stuck in it, then I tried again and got a second one on perfectly fine. Nothing wrong with E-cell, I will buy from them again. |
enk39
Joined: Oct 27, 2008
Posts: 120
From: NZ
PM |
wel i havnt used e-cell screen protectors before but you could try peeling the corner bit and snipping off just a tiny( 1mm or so) bit off the corner which jst helps it seal better if it's just the corner bit that's slightly worn | |
|
Access the forum with a mobile phone via esato.mobi
|
Posted: 2008-11-12 16:08
