| Author |
SonyEricsson K750.blink blink blink.HELP! |
tzdsc
Joined: Sep 18, 2008
Posts: 4
PM |
Hello all
I read a lots of posts here, but can't really figure out what can help me with my problem, so I'll write it down and hopefully someone will have time to help.
I got SE K750,
I took out battery today without turning my phone off first, and what happened after I placed the batt back and turned it on I see a white screen, blinking on and off every few seconds. I can't do anything....I even waited a few seconds, entered my pin, waited again then dialed a numb but nothing happens...So I guess my screen is not dead (only), probably something with software  or whatever...
I tried and downloaded those programs XS++ and SeTool2...but I have no idea how to use them! I mean, I don't know how can I find out what's the so called firmware and other codes and stuff...I really don't understand that.
Also when I connect the phone via USB to my PC it says that it's an undentified USB device...and there is no way that I can read the phone card. PC doesn't see the phone
I hope someone has time to help me out with this. Is there a program which can give a diagnose of "what is the problem with my phone"?
THANKS! |
|
|
strizlow800
Joined: Aug 23, 2006
Posts: > 500
From: Macedonia, Skopje
PM |
Try flashing the phone firmware... Use this tutorial:
http://www.esato.com/board/viewtopic.php?topic=156090
and download firmware files from www.4shared.com
your problem should be fixed then.
|
tzdsc
Joined: Sep 18, 2008
Posts: 4
PM |
How could I know what's my phone's original firmware and which one should I flash with and also what is the correct MAIN and CID...xyz...I really have no idea how to find the right files |
tranced
Joined: Jan 19, 2006
Posts: > 500
From: Santo Domingo, wonDeRland
PM |
hi
follow the steps given in this thread. then you will know some info about your phone.
|
tzdsc
Joined: Sep 18, 2008
Posts: 4
PM |
Thanks!
I installed usb flash driver,
But still when I use XS++ and connect my phone with USB port it it says:
Error: Cannot open phone communication port
Disconnected... Unplug the phone
It just doesn't read my phone. Though it keeps blinking white screen every couple of seconds. Nothing else besides that |
tranced
Joined: Jan 19, 2006
Posts: > 500
From: Santo Domingo, wonDeRland
PM |
try this:
On 2007-11-26 18:54:15, tranced wrote:
1- ok
2- connect the cable to pc only
3- click the connect button(The message appear and says 'Turn off the phone','Hold C and connect phone' ..(30secs)
4-press and hold the C key on the phone
5-connect the cable to the phone
it will be detected
|
tzdsc
Joined: Sep 18, 2008
Posts: 4
PM |
Doesn't work |
|
|
Posted: 2008-09-18 02:02
Sony Ericsson software/hardware support! 
