| Author |
K800 not turn on after SE update |
cosalex
Joined: Oct 24, 2007
Posts: 2
PM |
I have a K800 and it did not turn on, instead I was receiving a flashing red light at the IR port. I followed the suggestions of various posts and updated the EROM through Wotan. The red light disappeared and I could turn on the phone but when I was inserting the SIM I was getting a flashing white screen. Because I had all the contacts on the phone with no backup I did not proceed with a full flashing with Wotan, instead I updated "successfully" through SEUS in order not to lose the data. I ended up with a flashing white screen with or without the SIM this time.
My intention is to use myphoneexplorer prior to the full flashing but the phone is not recognised. Any ideas of how to proceed? |
|
|
RevoWution
Joined: May 26, 2007
Posts: 231
From: New Zealand
PM |
I think you might've bunged it up even more by using SEUS... Flash again with Wotan or with XS++. Apparently you can do it for free with XS++ now.
Sony Ericsson K800i (Concrete Silver) w/ R8BA024 Taiwan Casino Royale firmware, 2GB M2 memory card w/ various mods. My Wordpress Blog |
cosalex
Joined: Oct 24, 2007
Posts: 2
PM |
I have flashed it again with XS++ ... but the problem remains ... I even tried the full flashing but I still get the flashing white screen. |
hanugro
Joined: Feb 28, 2005
Posts: > 500
PM |
Try this again. Reflash with XS++ then turn on phone (Do not enter SIM or M2 card yet), see if it will turn on. If not you may try to flash EROM FOTA with XS++ (enter it as MAIN firmware). See if it helps. Patients is key let the phone for few minutes before asuming it hangs. |
clive
Joined: Apr 16, 2007
Posts: 8
PM |
Hi, I have the same problem only when i use this particular battery, try another battery |
|
|
Posted: 2007-10-24 10:27
