| Author |
HPM-70 and Voice Command, possible? |
Snoopa
Joined: Jul 27, 2005
Posts: 28
From: Paris - France
PM |
Hi all!
I've been trying to use voice command to place a call with HPM-70 and a W800i, but no luck. I have attributed a voice command to a contact, that I can hear when the person calls me. But I can't call that person with the same voice command.
With my old T610, I only needed to keep the remote button pushed down and say the magic word!
Thank you in advance for any help.
[ This Message was edited by: Snoopa on 2006-05-29 12:19 ] | |
|
Snoopa
Joined: Jul 27, 2005
Posts: 28
From: Paris - France
PM |
I finally found the answer to my problem on SE site.
In my case the voice command service needed to be activated!
Here it is if someone needs it too:
Start using Voice dialling
Press and hold the volume button on the side of the phone for two seconds. If you haven't activated and recorded any voice commands just follow the instructions that appears on the display.
When you want to make a call by using a voice command, press the volume button for two seconds and say your voice command.
Au revoir! | |
|
Access the forum with a mobile phone via esato.mobi
|
Posted: 2006-05-29 13:00
