| Author |
help on replacing LCD screen on T610 |
Saigon
Joined: Nov 02, 2005
Posts: 1
PM |
i recently dropped my phone and now the phone turns on but it only displays a blue screen. im not completely sure what the problem is but ive been told its my LCD screen so im about to replace it with a screen from another T610 but not sure on how to do it without causing more damage. any advice on how to do this or any instruction guides or is my problem with the software????
and yeah i know this model is old but i have a lot of information stored on it
[ This Message was edited by: Saigon on 2005-11-02 22:29 ] |
|
|
BobaFett
Joined: Jan 06, 2004
Posts: > 500
From: Kamino (wish it would be Lund)
PM, WWW
|
welcome her! sorry to hear bad news. dont u have the possibility to replace by se service or an expert. btw here was a thread of it with pix and details, gonny try to find it, but i cannot promise.
|
goldenface
Joined: Dec 17, 2003
Posts: > 500
From: Liverpool City Centre
PM |
Turn a bad experience into a good one. Use the opportunity to upgrade it to a T630 screen. Welcome ty Esato :-D
This message was posted from a S700 |
jagger2k
Joined: Nov 14, 2004
Posts: > 500
From: Leicester, UK Phone: IPh
PM |
replacing the screen is quite easy, first remove the battery cover, then get a small screw driver and insert it under the black antenna cover and gentelly pull it till its off, do the same for the antenna and then you should see 2 screws, undo the 2 at the top and bottom using a t6 screw driver, now turn the phone over and carfully pull the cover off, now pick the lcd screen up and you should see the conector, lift the plastic handle thingy and remove the screen, inset the new screen ribbon, and reverse the process. |
shug
Joined: Nov 05, 2003
Posts: 330
From: Sweden
PM |
http://www.howardforums.com/s[....]highlight=%2Bt610+%2Bfaceplate
This shows how to dissect the phone. Then just lift the screen and release the screen contact.The contact is quite fragile - a thick foil - so you might want to practise putting the old screen in again before you try inserting the new one
[ This Message was edited by: shug on 2005-11-06 10:35 ] |
|
|
Posted: 2005-11-02 23:27
