Author |
FAQ: Fixing a dead K800i |
maffy26 Joined: Mar 10, 2007 Posts: 9 PM |
i`ve tried this with my SE k800i and its not working |
|
maffy26 Joined: Mar 10, 2007 Posts: 9 PM |
Right on holding the power button i`m getting 4-6 flashing red lights.. i`ve followed the steps previous and it sticks at the wating part..
as well as that , my computer doesn`t seem or i dont know if it picks up the usb cable, i had to download the disc 2 phone software from the SE site and the SE PC suit software.
Anyone got any ideas on what else i can do here, its driving me insaine |
creo Joined: Mar 12, 2007 Posts: 1 PM |
Machanic you are a legend! My K800i became a brick after I tried to sync contacts with my PC using the SE PC Suite. It was dead dead, nothing on power up, no lights nothing. Anyway I tried your post and it sorted it just fine. Thanks a million.
I had a small problem with the drivers, I thought you meant the standard phone drivers had to be on the pc - which I knew were. Instead, it's the usb flash device drivers. The only way I could get them installed was to install the SE Update Service off their site ( http://www.sonyericsson.com/s[....]1&pid=10407&fid=21839&esi=true ) , and the PC needed a reboot after the install, and only then did the drivers install (Not at the beginning like it was supposed to according to SE) . Anyhow, once they were on it all worked fine, the WotanClient reported:
EPROM: starting upgrade
EPROM: done
== FINISHED OK ==
I was worried that my phone might revert back to being locked to 3, but it was still unlocked too!
Thanks again.
|
webchetan Joined: Apr 03, 2007 Posts: 10 PM |
Hi - Could anyone please help me out with my problem below?
Thanks in advance...
--------------------------------------------------------------------
Hi All - I have a K800i. I think I have a dead battery (got it from eBay for $1.99) . Please see the pics below. When my phone is turned off and I am charging it. It shows that the battery is charging via "Charging" indicator on the screen. (There is no red light near the Infrared port on the phone when PHONE is OFF and "Charging"). Btw, the screen shutsoff when charging and when i press "C" it comes back again. Is this by nature of SE K800i ?
Now when I turn on the phone it turns on for few seconds and turns off with a "steady" red light near the Infrared Port. (Pls. note that the light is not flashing! but just steady red color) Does that indicate that the battery is low? or exhausted? or is it the firmware ROM?
I think the fake battery (pictures above) doesn't seem to charge, then why does the Screen show "charging" when the phone is in OFF.
Btw does those batteries (figure above) look fake? Its seems to me that actuall the batteries are exhausted and is not charging.
Please advice.
Thank you,
- webchetan
[ This Message was edited by: webchetan on 2007-04-04 14:33 ] |
meglou Joined: Apr 05, 2007 Posts: 1 PM |
will this delete any thing on the phone i CANNOT have things deleted also will this work if the fone doesnt actually turn on at all???? |
Neo-Tech Joined: Sep 24, 2006 Posts: > 500 PM |
As I have said before nothing is deleted at all and no one has reported it.
If you get a Red Flashing Light then this will work.
Hope this helps
EDIT: I need to put this is PDF ASAP
|
irishphoenix Joined: Apr 09, 2007 Posts: 1 PM |
Hey, Just happened to me this morning too when i turned the phone off when the alarm was going off on it. When using Wotan do I press keys 2 and 5 on the phone keyboard or the 'c' button like the software suggests? Is there any indication in Wotan that it has found the phone?
Regards |
antz88c Joined: Aug 10, 2006 Posts: 297 PM |
I already flashed my w880i with R1KC001 CID52 and thought to give this 2 and 5 trick, unfortunately it doesn't work.
imagine. inspire. ignite. |
kentonhq Joined: Apr 09, 2007 Posts: 3 PM |
PLEASE HELP MEEEEEEEEEE!!!!!
I tried every possible ways to reflash my k800i dead phone and still it does not work. There is no flashing LED. The phone just does not turn on.
When I plugged in the USB cable that came with the phone to the PC, it does not recognize the phone. I have my phone battery fully charged. Reinstalled the sony PC suite on 3 different computers and tried the Wotan software on 3 different computers. Still the PC did not recognize my phone.
When I tried plugging in my other k750i, every single computer I used recognized this k750i, but not the k800i. |
hanugro Joined: Feb 28, 2005 Posts: > 500 PM |
It is still a mystery why some phone is not recognised by wotan. Your only option may be authorised service centre.
Wotan client will show your phone model and other info if it recognised your phone. If the screen remain blank the it still trying to negotiate conversation with your phone. |
Neo-Tech Joined: Sep 24, 2006 Posts: > 500 PM |
Some newer phones such as the new W phones may not be able to upgrade the EROM.
You have to press 2 & 5 together for it to work
|
scragga Joined: Apr 11, 2007 Posts: 2 PM |
Hi,
I'm having this problem as well. I have left the phone off for a while, and now it won't switch back on at all.
The red LED light for infra red flashes however when attempting to switch the phone on or charge it up.
I have tried to update it using Wotan as outlined in this thread, but to no avail. The problem I am having is getting the computer to recognise the device properly in the first place. I have installed PC Suite and all the necessary drivers, and when it attempts to connect, the computer prompts me to install a USB Flash driver... My other K800 phone is working fine with the same PC and PC Suite software however?
I would be grateful for any assistance. Is shorting the internal battery recommended or not?
Thanks |
scragga Joined: Apr 11, 2007 Posts: 2 PM |
On 2007-03-12 23:52:37, creo wrote:
The only way I could get them installed was to install the SE Update Service off their site ( http://www.sonyericsson.com/s[....]1&pid=10407&fid=21839&esi=true ) , and the PC needed a reboot after the install, and only then did the drivers install (Not at the beginning like it was supposed to according to SE) . Anyhow, once they were on it all worked fine.
I just did this, and although the update thing would not work with the C button pressed down, I instead tried 2 and 5 this time round and it installed the drivers and everything. After this point, started up Wotan and fixed the thing myself.
RESULT!!! Cheers to the author of this thread, much appreciated!!! |
hanugro Joined: Feb 28, 2005 Posts: > 500 PM |
Ah, it may shed some light here. Seems that most phone that is not recognised have not install USB flash driver (first time user of wotan/kulan client).
Installing USB flash driver in wotan/kulan needs the phone to be connected with pressing C (then the USB will pop up and ask whether they want to install USB flash driver). However I installed recent SEUS and observe that it will install USB flash driver anyway after you install it (not require the phone to be connected first with C pressed).
All those who fail to get the phone recognised seem that it has not install USB flash driver properly and trying SEUS first may help. |
kiori Joined: Apr 16, 2007 Posts: 8 PM |
On 2007-02-11 12:27:11, machanic wrote:
Hi,
I thought it was time someone posted a FAQ on how to fix a dead K800i. This is because there are over 100's of threads about dead K800i's.
The fix:
Equipment:
USB Cable (Provided in the box)
Your dead K800i
Computer
USB Ports
...and some software
Instructions:
1. First remove your SIM CARD and Memory Sticks from the phone.
2. Put the battery back in and DO NOT TURN IT ON.
3. Now if you have used your K800i with your PC before then you will not need to install the drivers. If you haven't used it before, then get the PC Suite disc and install the drivers manually by browsing the disc.
EDIT: If that doesn't help please install SEUS from this link http://www.sonyericsson.com/s[....]1&pid=10407&fid=21839&esi=true , Make sure you don''t update your firmware until you have fixed the phone
4. Now you need to click on this link and press download and save it to your desktop. http://www.wotanserver.com/su[....]=viewdownload&downloaditemid=1
5. After it has downloaded then go to your desktop and open the file up.
6. It will start to update, DO NOT CANCEL IT.
7. On the bottom-right hand side corner there will be a login box. Make sure there are blank before you start otherwise it won't work.
8. Once the update has finished. plug the USB into the computer and NOT THE PHONE.
9. Press start in Wotan
10. Press 2 and 5 simulatenously and plug your phone in.
11. Let it finish
Take out the battery for a few minutes and then put it back in
Now you can enjoy your fixed K800i
Suggestion:
NOT RESPONSIBLE FOR ANY DAMAGE
If you are very scared of updating your EROM then you can try shorting the battery connector (NOT THE BATTERY ITSELF) in the phone using a spoon.
It may work or it may not
P.S Hope it becomes a sticky
_________________
Just got my lovely phone. Sony Ericsson K800i
Computer Genius to the rescue.
Register on my forum today. http://mo1205.forumer.com
[ This Message was edited by: machanic on 2007-02-11 11:28 ]
[ This Message was edited by: machanic on 2007-02-16 07:05 ]
[ This Message was edited by: machanic on 2007-04-13 07:54 ]
I WAS TRYING BUT I DONT KNOW HOW TO INSTALL THE DRIVER MANUALLY WITH THE CD PLEASE TELL ME THE STEPS, AND IF DONT INSTALLL THE DRIVER YET, IS POSSIBLE THAT THE PC CAN RECOGNICE THE K800
SORRY FOR MY BAD ENGLISH |
|