Welcome to Esato.com




W800i USB cable connection issue


Click to view updated thread with images




Posted by marc_alan
okay, every time i load mp3s to my W800i using the supplied USB cable, connection gets terminated in the middle of the transfer, the Disc2Phone software reports that there is no device attached.

before i start, i make sure that everything is OK, phone is steady and is not moved, but still get disconnectedin the middle of transfers.

another thing, whenever i use that same supplied USB cable to charge my phone, it seems to discharge it. am plugging it to a toshiba satellite A80, drivers installed. initially shows 25% batt life, i leave i plugged in for about 30mins, when i check it again, battery bar is in red zone, saying 10%!

is the cable defective or something?

thank you!!

Posted by JudgeJules
After Reading this post ive noticed the same thing

Posted by marc_alan
well, ive finally gone and had my fone checked, i said i wanted to have my firmware updated... the sony ericson shop told me i have the latest firmware, but i insisted they'd flash my fone and re-install the firmware anyway...

so i went back to the store after 2 hours, they tell me that thay cant seem to flash the fone, they keep getting a cannot flash error message, and advised me to leave my fone, it might be a faulty board ...

ah well....


Click to view updated thread with images


© Esato.com - From the Esato mobile phone discussion forum