| Author |
w800 Dead |
henno2000
Joined: Feb 13, 2003
Posts: 17
PM |
Hi,
I was updating my firmware on my w800 using GFlash and now the phone will not even switch on.
I have ensured that the battery is fully charge via an external charger, the correct USB drivers are installed and the cable is functioning. When I reconnect the battery and USB cable and hold either 'c' of '2 + 5' nothing happens.
I have also noticed that the phone does not even charge up when the the phone is plugged into the charger (hence the reason why I have had to externally charge the battery)
Is the phone dead, or can it be saved? (How do SE originally flash the firmware onto a blank phone?)
Regards,
henno2000 | |
|
Boysie99
Joined: Jan 17, 2008
Posts: > 500
From: Southampton, England
PM |
Use XS++ v3.1. Try and connect it and post the log results here please. 
"There are only two things that are infinate, the universe and human stupidity, and I'm not sure about the former." - Albert Einstein  SE-NSE VIP - K800i Expert modder | |
|
Access the forum with a mobile phone via esato.mobi
|
Posted: 2009-06-12 09:19
