Author |
HELP WANTED w950 touch screen |
wiqi46 Joined: Apr 24, 2007 Posts: 30 PM |
hi all!
i bought this w950 and found this one amazing. but after 10 days there is a problem. its touch screen is not functioning properly. the problem is like this
at the bottom of the screen the screen is pressed exactly where i touch the stylus but as i go up there is a gradually increasing gap between the pressed screen and the stylus touch. at to top the gap is about 1 cm on the lower side (ie screen is clicked 1 cm lower than the stylus position)
please help me. i have done a master reset. flashed it with sues.
what else to do.
thnx in advance.
Plz reply |
|
hydro- Joined: Aug 31, 2007 Posts: 137 PM |
Hey same problem here happend just 3 days ago and i cant unlock my phone atall! |
AD Joined: Aug 25, 2005 Posts: > 500 From: UK PM |
Did you try recalibrating the screen?
Control panel - other - Setup wizard - Next (repeat untill the Calibration screen)
[ This Message was edited by: AD on 2008-08-12 10:24 ] |
gezer Joined: Feb 07, 2008 Posts: 109 From: PM |
if your touchscreen is damaged i can say youre lucky. because only touch part replacement is about 5-10$. |
wiqi46 Joined: Apr 24, 2007 Posts: 30 PM |
thnx AD. you solved my problem. actually i read a lot about screen calibration but i never used the setup wizard in the control panel. i only go through the setup wizard that i shown at 1st time phone start-up. and that one does not have any screen calibration.
thnx again |
AD Joined: Aug 25, 2005 Posts: > 500 From: UK PM |
You're welcome |
|