Forum > Sony Ericsson / Sony > Software, Firmware and Drivers > Raider camera driver for K790, K800 and K810 (v6.6.5)

Posted: 2010-01-15 11:41

6.6.5  [2010-01-15]

       - after camera start exposure correction (EV) can be set like in original driver

         using joystick left/right - open the camera, correct EV if necessary and take picture.

         this is most intuitive and fastest method to correct EV if you don't use manual

         functions for other settings, otherwise:



         selected in this way EV correction is canceled after first change in any manual

         function, except of function at position 0.0 which is neutral EV position



         for example:



         1) you want to set focus infinity/other using manual focus (function 0.0, step 1)

            do it and you still will be able to change EV correction using joystick



         2) you want to set SEM mode (function +1.0, step 1)

            when you go to function +1.0 you'll notice change of EV correction (to +1.0EV)

            but if you then set step 1:

            * the camera is informed that change of EV position was not EV correction

              but selection of position to function which you just changed

            * EV correction will go back to auto value (0.0EV for most scenes)

            * EV correction using joystick is no longer possible until you close and open

              camera again