Author |
Is it possible to build IR dongle for Ericsson |
vital_lunokhod Joined: Oct 28, 2002 Posts: 14 PM |
that has no IR port? Can't find the device on stock, may be it's possible to repeat a scheme by myself? Where can I find solution?
Thanks a lot |
|
maximiliamd endecavour Joined: Nov 03, 2002 Posts: 37 PM |
Try here (if is that what you mean)
- http://www.infraredport.com [In English/German]
- http://web.tiscali.it/ikona/irda.htm [In Italian]
- http://www.desantis.archimedianet.it/Appunti%20Elettronica/Null_modem_ir.html [In Italian]
The first 2 sites tell you how to build an IrDA adapter to connect directly to your MotherBoard.
The last site tells you how to build an IrDA adapter to connect through the serial port (RS232).
The two sites in italian are easy understandable, the only translation needed is for led colors:
verde = GREEN
rosso = RED
The other information in italian are not necessary.
I hope I've been helpful.
Bye
[ This Message was edited by: maximiliamd endecavour on 2002-11-25 20:43 ] |
vital_lunokhod Joined: Oct 28, 2002 Posts: 14 PM |
I saw these sites, but does that mean that I can call phone "motherboard"? |
maximiliamd endecavour Joined: Nov 03, 2002 Posts: 37 PM |
Sorry, I didn't understand well your question...
You asked for instruction on how to build an Infrared adapter for the phone, while I understood that you were looking for infrared adapter for the PC.
What a big mistake...
Sorry!
Hope you'll find what you're looking for. |
vital_lunokhod Joined: Oct 28, 2002 Posts: 14 PM |
Not at all.. Can't find anything... May be I should buy some IrDa device and re-build it and connect directly to serial output of the cable? |
Black Cat Joined: Oct 21, 2002 Posts: 165 From: Loughborough UK PM |
which phone is it for?
ericsson used to make a connector for their old non infra red handsets (i think they were called the dir28 & 29, but i could be wrong. they certainly made them though) |
maximiliamd endecavour Joined: Nov 03, 2002 Posts: 37 PM |
Quote:
|
On 2002-11-26 16:10, vital_lunokhod wrote:
Not at all.. Can't find anything... May be I should buy some IrDa device and re-build it and connect directly to serial output of the cable?
|
|
It may be a solution...
But, then, is better to use the cable!!!
You can build it! If you want I can post you the link for the electrical scheme. Which model do you have? |
vital_lunokhod Joined: Oct 28, 2002 Posts: 14 PM |
I have the cable, and everthing's fine with it. But I going to change Palm III to Sony Clie that has no serail port but USB. More, that cable stuff is too much to be called "moblie office"...
Phone is Ericsson T200 |
|