Posted by afv
Hi, I flashed my K700i with last firmware (R2AE033) using davinci and then the phone worked about 5 minutes but after that, the screen started flashing white.
Now, when I try "Read CID", it says:
Client Version 12.5
**** READING CID STARTED ****
Power on the phone!
Detected SonyEricsson: K700/F500/K500/S700/Z500.
Dead Phone detected!
Recovering process started!
Status Ok, OTP Close, CID29, PAF1
IMEI: xxxxxx-xx-xxxxxx
Flashing 1 blocks...
address: 00000000, block: 1/1
Last sub block not accepted
SSW header not accepted!
SSW header not accepted!
SSW header not accepted!
Flash Loader not accepted
Execution Time - 00:03:52
Done!
What should I do?
[ This Message was edited by: afv on 2005-03-09 16:58 ]
Posted by hohohong
Same thing happen to me when I update software at SE website! I have the DSS-25 stand,... after completed, it started flashing white screen!!
Help
Posted by vineet_d
U must go to the authorised service center and get it reflashed.....this should solve the problem.
Posted by hohohong
I can't reflash from SEUS? with DSS-25 stand? Thanks for you reply.
Posted by govigov
| Quote: |
|
there is a repair/restore something in that site, you might want to try that.
Posted by whizkidd
Haven't you got any service centre near you?
Posted by Sebby
Suggesting a service centre is no good as the phone has been flashed using DaVinci, which theoretically voids the warranty.
I'm sure DaVinci has a method of doing a full re-flash. I know SE Tool does. Contact the DaVinci team and explain the problem, and I'm sure they'll tell you the answer.
Posted by HyperiaBlue
Maybe you could try using SE tool to recover it...but of that i am not sure.
Posted by hohohong
I tried using SE tool to recover,.... but still the same thing!
I don't think there's SE service center new by. I bought this K700 online. K700 is not even officially introduce in my city.
Posted by HyperiaBlue
I suggest the following then:
Get yourself a DSS-25 synchstation, load the drivers onto your pc and then try to use SEUS (
's update service) but select recovery mode when you are about to flash it. The service should be albe to recover your dead phone.
Here is the link to SEUS:
http://www.sonyericsson.com/s[....]7_x&zone=ps&lm=ps1_1&pid=10139
Give it a try...it may just work.
_________________
Sony Ericsson - the marriage of the consumer electronics Beauty to the telecomms Beast[ This Message was edited by: HyperiaBlue on 2005-03-11 15:57 ]
Posted by KrisUK
| Quote: |
|
Unless the firmware flashed from Davinci would show the service centre the phone wasn't flashed with SEUS, they won't know any different but yes it is supposed to void the warranty.
I wouldn't bother contacting Davinci for help after a bad flash though. I did and they never gave me any help but just their credit price list.
Posted by govigov
In that case try www.setool.net
Posted by Residentevil
Updating your phone over the internet is a risky business. I killed my phone this way and had to send it to the service center for repair. If it isn't broke, don't fix it.
Posted by ManiacMatt
did you have any luck with this??
Posted by afv
I've sent the phone to service center for repair..
I'm still waiting..
Posted by gbrooks3
impossible to kill phones with software, i challenge anyone to do it that cannot be fixed
