Posted by Noddy_36
Hey, I jst bought a dcu-11 cable, to use for my SE k700i I installed the drivers, installed the software but everytime i try and use any of the features, it says "no k700i connected", i used jst a standard cable for my T610 and this worked fine and this but i haven't been able to connect with eithor cables for my k700. Any ideas please
Posted by wapt
Has the com port for usb cable been checked in the mobile phone monitor? The com port other than build in ones.
Posted by Noddy_36
How do i do that? all i did was install the cable drivers and the pc suite software, plugged my fone in, everytime i plugged it in the software on the pc suite sed was "not connected".
Posted by anand.balaji
Try rebooting your phone. It sometimes works...
Cheers.
Posted by k4m!k4ze
Use FMA -
http://fma.sourceforge.net
or K700 DateiManager -
http://k700.hitziger.net
They're faster and better than SE software.
Posted by CyberVisitor
@Noddy_36
For many people who use applications depending on the Sony Ericssons Mobile Phone Monitor, this is a common problem. The solution for those people is to use applications that don't depend on it, like floAt's Mobile Agent http://fma.sourceforge.net/
[ This Message was edited by: CyberVisitor on 2004-11-28 17:50 ]
Posted by Noddy_36
If i use that FMA thing is it compatible with a usb cable?
Posted by CyberVisitor
@Noddy_36
Yes it is. First install the driver for your USB cable. Then, under hardware settings in your PC, check your communication port ID for your USB cable and enter the same number in the FMA settings and everything will work fine.
[ This Message was edited by: CyberVisitor on 2004-11-28 17:57 ]
Posted by Noddy_36
Cheers, appreciate it, gona start d/l the setup file now, hope it works