Posted by djordje1yu
Hy! I bought P900, and I got with it DSS-25. When I connect P900 it works excellent, but when I try to connect m k700i, it says "connecting" (in Phone Connection Link properties), and nothing happens. I install drivers, but it still don't reconize my K700i??? What is the problem????? Thanx.
Posted by Sir-SonyEricsson-man
try to install the progs that followed the phone. that might help, not that from the P900.
Posted by djordje1yu
Problem is, that I haven't got anything with my phone. But I have installed those programs (MMS Home Studio, Sync Station, Dial Up menager.........). I think I need drivers for k700.
Posted by Sir-SonyEricsson-man
you can get all drivers from the SE site.. Just try to uninstall everything you have now.. and install it again
Posted by teslaguy
I tried with the DSS-20, same case. Installed P800 PC Suite (i didn't know there were syncstation drivers on the K700 CD), nothing, then i installed the K700 PC Suite when i noticed, nothing! Well went to the site upgraded the firmware just fine so it must be a software problem and not driver or hardware problem
Posted by kenski
hello guys, what I did was just to download dss driver from se site then plugged the dss-20 I bought. After that I proceeded with the upgrade it worked liked a charm. Not a single error
All I did was install the dss-20 driver. I didn't even install pc suite.
_________________
forever
Read the FAQ before u post a new topic..
8810->6150->3310->t68i->t610->t630->k700i
[ This Message was edited by: kenski on 2004-09-19 17:53 ]
Posted by djordje1yu
But on SE site there are only drivers for dss25, and they say that thay are only compatible with p900!!! Anyway, I still didn't menage my dss25 to work with my K700...
Posted by joebmc
have you tried the update anyway?
Posted by djordje1yu
I tried, but they said: "Your phone isn't connected", or something like that.....
Posted by dimmdesign
I had the same problem. but i solved it a while ago. you just have to do the followings to get it worked. Go that little black phone down where the clock is, right click on it and select configure then select the com ports tab and enable the com4 and it will work for you.
Posted by djordje1yu
There it says 'connecting'. I enable the com port, and in that row that says 'status' it says 'conecting', and nothing happens. But problem is that it won't start 'conecting' till i plug off phone from the DSS-25, and then it start connecting, when phone isn't connected!!!
Posted by Rookwise
I got my K700 working by downloading the drivers from
site and changing the com port in phone monitor. Works every time now.
You could try these tpoics as well
http://www.esato.com/board/viewtopic.php?topic=63929
http://www.esato.com/board/viewtopic.php?topic=63863#post830815