Posted by Stinger151
Can someone give me a little guide on how to to flash phones.and also how to update a T68 to a T68i myself please
Posted by Lynx69
Have a look at Cellular Support There are some good tutorials there.
Posted by Stinger151
Thanks,anyone else
Posted by punkserb
everything you need is at that site. just read. it is the best there is for SE.
Posted by Merovingian
Here is a short guide, do it on yur own risk:
YOU ARE FOLLOWING THIS GUIDE ON YOUR OWN RISK!
I TAKE NO RESPONSEBILITY FOR ANY DAMAGED PHONES!
What you need:
1.terminator dongle
2.DIV 8.4 or equalent
3. AVR, ARM (and GDFS if unbranding) files
Be sure to have your battery fully loaded! I have done this with my battery under halfful and it went great, but it is recomended to have a fully charged battery.
Turn off your phone, take out the battery for 1 minute or more. Plug your dongle into the phone and put the battery back into the phone. DO NOT TURN ON THE PHONE YET!!
Start DIV. Select the right phone type, in this example T610
Mark the box "Flash AVR CPU with" and select the avr file, etc T610_EU4_R4C003.sbn
Mark the box "Flash ARM CPU with" and select the arm file, but be sure it has the same extension as the avr file, etc if avr is T610_EU4_R4C003, then the arm file must be T610_Standard Modem_R4C003 or T610_EU4_Modem_R4C003.arm
if you just gonna flash your phone stop here, and press "Make selected jobs". Hold your ON button in, but not to long. DIV will say Initializing boot, bypassing boot authority, load data for flash and so on.. now it will count slowly up to 100% and start over and flash the ARM CPU.. than it will say "Operation Succesful".. take out the cable and power on the phone.. It will be a little slow when you start it, cause the firmware must initialize...
If you are unbranding your phone, forget about checking out the ARM and AVR boxes, instead, check out the "Write GDFS with" and select T610_Original_GDFS.gdf
press "Make Selectet Jobs" button.. it will flash it.. power on your phone, and the Vodacrap/o-2/T-mobile icons should be gone
you may have to use "Rebuild SP area using OTP IMEI" button, but I doubt it.
Anyways, this will void your waranty, it can damage your phone if not done correctly. YOU ARE FOLLOWING THIS GUIDE ON YOUR OWN RISK!
I TAKE NO RESPONSEBILITY FOR ANY DAMAGED PHONES!
cheers, mero
Posted by kimcheeboi
| Quote: |
|
the fbi will tell you how to flash your phone?
Posted by methylated_spirit
Its not going to the FBI site any more, its back to normal
Posted by kimcheeboi
yay!
does it still have all the files?
Posted by Stinger151
i was just in need of the info and guide on how to upgrade T68 to T68i please also the software as celluar support is shutdown
Posted by Stinger151
ok can u just tell me wat software i need and wat i need to update eg. arm , flash
Posted by Stinger151
ok i flashed avr cpu with T68i_full_GDFS_in_AVR_flash_format.sbn
but now i have 1 problem it wont turn on when i try to reflash or repair it says ERROR 0101 please help