Posted by DgtHorse
ok i put my headset in pairing mode, then i try to discover the headset, sometimes it finds it sometimes it doesn't. When i do i enter the passcode 0000 and it fails, so i try entering the passcode about 10 times and it never works. Can someone please guide me through. Thanks
Posted by Orion
I'm getting the same problem. I was able to use the headset for a 20 min call but then it died right after that. Now most calls IF it does work last only a few seconds. I'm wondering if I get a Ericsson Bluetooth headset if it work better?
Have you had any luck?
Posted by Fingers
I'd take it back and try and get another, if it still doesn't work try another make, or you could get them to try in the shop you got it from, they may see somewhere you're going wrong that you haven't noticed. Just an idea. Hope you get it sorted
Posted by Orion
Aye, I'm going to pass by the store on my way home today. Problem was at the store near my home they told me this only works with the Motorola phones but at another store and on this forum I was told it would work. Hopefully just a new headset will fix it.
Also the sw on my t68 is R2b013, do I need the new sw for it to work with
1.1?
Posted by lesneo
Personally, I too feel that the Motorola bluetooth headset is much cooler looking than the ericsson one. May try getting the former instead of the latter due to the "form" appeal.
Posted by Orion
Well I went back to the ATT store and switched the headsets and I'm happy to say it works GREAT. I brough it home and charged it up and reset my phone back to the factory settings. I then had the phone detect the headset and it works great now. Not running into any problems and I've made a few calls already. The headset is light enough I'll use it around the house when I need my hands free.
I admit I though it looked builky and wanted the ericsson HBH-15 but after holding both in my hands I find the motorola a lot easier to carry around and by closing the boom I dont have to worry about it breaking off
This will keep me happy till the bluespoon is availble. Thx all for you help.
Posted by fipool
If your t68 doesn't find your Motorola headset easily/always, try to reset the headset. You have to open its cover for that, but it did help us.
Posted by arroyootje
Is it safe to open the cover?
Posted by Orion
The manual said all you need to do is to plug the headset into the power adapter for 5 seconds for that. But that didnt work for the one I had before I exchanged it.
I assume you should be able to open part of it to change the battery but if it's working I ant going to mess with it
Posted by arroyootje
I've just ordered two from Expansys, but they're taking forever and now F*ckExpress has taken over so I suppose I'll get my headsets when something new comes out...
Posted by JiggyJaggy
right you lot.....listen up!!!
joke. i had the same problem of my motorola headset not pairing.
this is what you do...
1) tun on the headset WHILE it is shut until the blue light comes onAND STAYS ON CONSTANTLY!!!
2) now go to paired items on your phone and add new. it should find the headset no probs
3) enter pass key...might take one or two attempts.
the reason you guys are having probs is cos the headset is flashing when you try pairing it. it must stay on constatly.
hope it helps Jag
Posted by JiggyJaggy
oh damn i forgot to say after you turn it on and the light is constant...open the headset immeadiatly. light should stay consant.
Posted by Orion
The problem wasnt the part about pairing it. Those instructions are the same ones that are given on the quickstart guide. I think a few of us just had a faulting one. After adding it, it would work for a few minutes and then just go out and get lost.
I exchanged mine and the new one works great. After pairing it I havent had a problem using it at all. I use the botton on the headset to activate the voice dialing and to answer calls all the time. Been using it for a few days strait without a problem.
Posted by arroyootje
I had loads of probs pairing mine, but then I opened it and press a little button (don't even know if it's the one you were talking about) but afterwards, it worked fine.... I do think the low volume is VERY disturbing..... I don't think I'm going to keep it.... I can't really use it, cos of the sound.... It does look cool though...
Oh yeah... do you guys have a lag between pressing the button and waiting for you phone to respond???
C U
Posted by iriequicksigns
1. Yes, there is a slight lag.
2. The top of the earpiece could use a bit more padding, it hurts slightly to wear it all day. You keep squeezing your ear more each time you answer the phone by pressing the little headset button.
3. The battery life is not that wonderful.
Posted by arroyootje
I don't press the button to answer, just say : "answer" and the phone does it immediately.....
Posted by iriequicksigns
I have not been able to get it to answer by just saying "answer" even though I have the option on an"aswer" & "Busy" voice coded.
BTW, What functionality are you supposed to gain from setting the magic word option?
Posted by arroyootje
I wait until the beep goes in the headset and then just say ANSWER or GO AWAY (instead of BUSY).... it works fine... try deleting them and recording them again.
The Magic Word means that your headset will be listening out for the magic word at all time.... this means you won't have to raise your hand to press the option button on the headset! you just say the magic word, wait a sec. until you hear the beep and then say the name.....
Could you be more lazy????
It eats your battery away though.....
Posted by iriequicksigns
Thanks for the info...I think that I'll have to erase and re try.
Posted by bogdan_wrc
hellp me. please.
i got myself a Moto A925 and it came with a BT headset. don´t even know the name of the headtset. unfortunatelly, in the instruction book, it does not say anything about pairing, turning on th headset..anything. like it did not exist. please help me pair the BT headset, and explain how do i turn it on...and use it.
thanks!!
Posted by *Jojo*
@dgt orion - What Motorola model headsets did you have then
I had some problems pairing my HS820 with my V3 a few days back . . . though it was paired by my celfone technician last weekend. Yeah, Jiggy Jag was right with the FIRST move when pairing . . . everything else will and should follow smoothly. When I tried looking for some feedbacks on my HS820 on Google, I found out that YES (again), it can be paired with other celfone brands/models a limited count though . . . maybe that's what's causing you trouble mates . . . your BT headsets are NOT compatible with your fones
Posted by stevemiddie
Hi. For whats it worth....... I,ve got the Moto HS 801 headset and it pairs just fine with my D750i ( fw version 35)
Posted by bogdan_wrc
i just found out that my BT headset is Moto HS801. ok, so after pairinghow to use it, cause when i dial, i hear the other person in phone speaker, not in bt headset, although i have the bt on at both devices. i really need this help. thanks
Posted by bogdan_wrc
nobody cand help me pair my BT headset with Moto?..hard to believe
Posted by *Jojo*
@bogdan - Wjat's the brand/model of your fone mate
Maybe this post by JiggyJaggy on the 1st page will help pal:
_____________________________________________________
right you lot.....listen up!!!
joke. i had the same problem of my motorola headset not pairing.
this is what you do...
1) tun on the headset WHILE it is shut until the blue light comes onAND STAYS ON CONSTANTLY!!!
2) now go to paired items on your phone and add new. it should find the headset no probs
3) enter pass key...might take one or two attempts.
the reason you guys are having probs is cos the headset is flashing when you try pairing it. it must stay on constatly.
hope it helps Jag
oh damn i forgot to say after you turn it on and the light is constant...open the headset immeadiatly. light should stay consant.
______________________________________________________
Posted by bogdan_wrc
it says earlier I have a Moto A925.
i managed to pair it, but now i don't know how to use it. i mean the blue light from the headset is flasing, but when i dial, it still does not connect to the bt headset.
really weird.
Posted by *Jojo*
@bogdan - When you already paired the headset with the fone, all you have to do now is open (turn-on) the headset, that flash will be on for about 5 mins. then try making the call . . . in my V3 it has an option to use Bluetooth when the call is in progress, from there, I can now use the headset mate. Or you can opt to turn-on the fone's BT prior to the call, so it can already detect the BT headset (turned-on) . . . Btw, I am using a HS820 Headset: