Posted by bhang
I have a t68i and a jabra freespeak and I have found it very tricky to record the voice commands thru the headset... This is important because the commands I made with the phone mic don't work when used via BT, I have managed to save some but I have to do some fancy finger work to get it to work and I can never seem to repeat the same results twice.
The commands I have managed to save with the headset work great but it takes me like 20-30mins and millions of attempts to get the headset to connect at just the right time so the phone will feed the record prompt
I have gotten it to work a few times like this:
1 select tag to be changed
2 replace tag
3 press the button on the BT set
4 if im lucky the beep will go to the BT set and I can record the tag
most of the time it will get to step 3 and then the headset will connect and then disconnect and the phone responds "sorry nothing heard" or the phone and the BT will lock up looping about 5 seconds of audio over and over thru the internal speaker and my BT...
Anybody got any suggestions?
there must be a way to pipe all audio to the bt all the time, if I connect the set manualy(via the bluetooth menu) and then try to record a voice command it acts as though it was never connected.
t681:
r5d007
prgcxc125544
bt200:
do they have different version firmware?
bhang
ps: I live in the states so upgrading is a pain in the ass, but it is possible...
Posted by bhang
I have gotten around this bug by recording tags with the phone mic that are very different from each other and longer than my old ones 10-15 secs, I have found that speaking the last 4 digits of the p# works well or the # and street name of the house which the phone you want to call resides in.
I would still like to record with the BT200 mike but this works ok, and with no replies in 24 hours I doubt i'll be finding any help anytime soon... I have this on email notify so if your reading this sometime down the road go ahead and reply.
bhang
t300,t68i
Posted by augustborn9917
i recorded my voice commands thru the phone mic, and ive had NO "no match" on my JABRA BT200. before i bought the BT, i recorded the voicecommands/dial in a completely silent environment and in a normal (not emhasized) tone of voice (almost hushed). i did however, replace my JABRA because of poor range/static/crackle (3ft!) that seems to have plagued the earlier versions of BT200
ps.
when all else fails, delete
the pairing and then re-pair
_________________
just a misplaced letter separates me from being "witty" to being "twitty"
[ This Message was edited by: augustborn9917 on 2003-08-12 23:57 ]