face plate cover Q - Esato archive

Posted by DimGR
hello
i found on ebay some t68i face plates for $7.50
good deal i think

is it as easy as it sounds to change face plates? remove the 2 tiny screws , then the built in ant1 and thats it?

Posted by insyder
AND MIC, AND EARPIECE...ETC. NOT SO EASY...

Posted by nizzan300
If you want you could goto a shop...they'll always pop it on for ya.

Posted by joebmc
just remove the first 2 screws (with t6 screwdriver) then the arial cover then 2 more screws pull off front cover carefully, and put the vibrater (located middle of origanal cover) onto the new cover.

No you dont have to touch the mic or earpiece, pretty easy!

[ This Message was edited by: joebmc on 2003-04-11 17:16 ]

Posted by abe214
I changed my T68i faceplate recently and I found it surprisingly easy for a newbie like me. Go ahead but read on guides found here. Esato has a wealth of information.:-D

Posted by binoblaine05
good mawnin peeps!