Posted by ayejatt
I recently replaced the housing of my phone and wanted to know if someone here have those special printers and can make me one for the new housing.
Thanks
Posted by ayejatt
no phone repairers here? :S
need one for a w900i
Posted by kenoby
I highly doubt someone will tell you if one has it
Posted by gregface
On 2008-04-04 14:51:00, kenoby wrote:
I highly doubt someone will tell you if one has it
lol, do they even exist for the public?
Posted by Muhammad-Oli
I would doubt it too, as it would allow scammers, thieves and people who make fakes to make up IMEIs that look real and they'd be able to scam more people, etc. And I highly doubt that any of it would be legal.
Posted by A L 3 X
can't you submerge your old housing in boiling water and then carefully peel it off...then glue it onto your new one
Posted by ayejatt
wouldnt the boiling water remove the letters on the sticker?
Posted by A L 3 X
dont think so.....will have a look at one in a sec
Posted by ayejatt
please do.
that would be easier then
Posted by A L 3 X
right....had a little look on my sisters SE.....it seems to be printed on well but am not too sure
If i were you id put a splash of boiling water on a little section of it but dont rub it in...or you could try warm but not boiling water
worst case though will be that it will rub off....you wont be able to use it on the new housing without trying so its up to you
Posted by gregface
Older phones like w800i and k750i, the sticker is designed to rip up when you try and peel it off, newer phones like w910i its easy to get the sticker off, but it curls up when you do.
Posted by ayejatt
thats what happen with a w900i sticker, it got cuts on the sides so it rips..
Posted by sielski666
don't submerge the phone hold it over a kettle while it is boiling,then as it does with a letter it will just peel off