Welcome to Esato.com




Is it possible to build IR dongle for Ericsson


Click to view updated thread with images




Posted by vital_lunokhod
that has no IR port? Can't find the device on stock, may be it's possible to repeat a scheme by myself? Where can I find solution?

Thanks a lot


Posted by maximiliamd endecavour
Try here (if is that what you mean)

- http://www.infraredport.com [In English/German]

- http://web.tiscali.it/ikona/irda.htm [In Italian]

- http://www.desantis.archimedianet.it/Appunti%20Elettronica/Null_modem_ir.html [In Italian]


The first 2 sites tell you how to build an IrDA adapter to connect directly to your MotherBoard.
The last site tells you how to build an IrDA adapter to connect through the serial port (RS232).

The two sites in italian are easy understandable, the only translation needed is for led colors:
verde = GREEN
rosso = RED
The other information in italian are not necessary.

I hope I've been helpful.
Bye

[ This Message was edited by: maximiliamd endecavour on 2002-11-25 20:43 ]

Posted by vital_lunokhod
I saw these sites, but does that mean that I can call phone "motherboard"?

Posted by maximiliamd endecavour
Sorry, I didn't understand well your question...
You asked for instruction on how to build an Infrared adapter for the phone, while I understood that you were looking for infrared adapter for the PC.

What a big mistake...

Sorry!

Hope you'll find what you're looking for.

Posted by vital_lunokhod
Not at all.. Can't find anything... May be I should buy some IrDa device and re-build it and connect directly to serial output of the cable?

Posted by Black Cat
which phone is it for?
ericsson used to make a connector for their old non infra red handsets (i think they were called the dir28 & 29, but i could be wrong. they certainly made them though)

Posted by maximiliamd endecavour
Quote:

On 2002-11-26 16:10, vital_lunokhod wrote:
Not at all.. Can't find anything... May be I should buy some IrDa device and re-build it and connect directly to serial output of the cable?



It may be a solution...
But, then, is better to use the cable!!!
You can build it! If you want I can post you the link for the electrical scheme. Which model do you have?

Posted by vital_lunokhod
I have the cable, and everthing's fine with it. But I going to change Palm III to Sony Clie that has no serail port but USB. More, that cable stuff is too much to be called "moblie office"...

Phone is Ericsson T200


Click to view updated thread with images


© Esato.com - From the Esato mobile phone discussion forum