Posted by paul.
I would like to upgrade my camera to the Super Camera using FAR manager and possibly get rid of the optus logos and operator logo and unlock the phone.
I read the subject on how to use it, and followed the steps, but wafter plugging in the phone it says it cant work cause I don't have EPIUSB.SYS, where can I get this, and do you need a special cable to do this?
Please help
Thanks
Posted by EvoLifE
EPIUSB.SYS can be found at the end of the first post in this topic:
http://forums.se-nse.net/index.php?showtopic=3209
It's in the "Win_USB_Driver_old.zip"
I think the cable is dcu-60, the one that came with your phone, but I know nothing more.
[ This Message was edited by: EvoLifE on 2006-12-17 23:26 ]
Posted by paul.
I downloaded it, now where do I put it?
What I do is after I press ENTER THE MATRIX, I hold the C key and plug in the cable whilst holding the C key, then when I have the cable plugged in, I release the C key. It loads up to 100% and then says it can't find EPIUSB.SYS and to install it.
Also, I plug the phone in while it is off and with no SIM in.
Am I doing anything wrong?
Posted by paul.
OK, now I have installed it properly, I have gotten past the MATRIX and into a part where it says FLASH and FS, when I click on either FLASH or FS, niether of them have anything in them, is this normal?
Also, how do I go about installing the Super Camera?
Posted by marionico07
I think your phone is CID49 and FAR doesn't support it.
I had the same problem with my W550i.
Posted by paul.
How can you fix/change that?
Posted by paul.
Also, how can I check this, DaVinci insn't working at the moment.
Posted by tranced
you cannot change CID's. newers
phones come CID49. Far Manager supports CID36 phones.
Posted by marionico07
check this... http://forums.se-nse.net/index.php?showtopic=6118
maybe it helps!
Posted by paul.
Is anyone planning on bringing out some sort of patch so that you can use it with CID49's?